Hired-hand RollSeal Rollup Curtains: ROLLUP CURTAIN SYSTEM Re Manual de usuario descargar pdf (Pagina 29)

Part No. 4801-5138 Rev 11-05 Rollup Curtain System Page 29

14. End Pocket

NOTE: C-channel should be cut to length of pocket.

1. Detail A. Fasten C-channel to brackets with sheet metal screws to form C-channel assembly. Repeat for

top C-channel, middle C-channel, and bottom C-channel assemblies. Be sure to use correct bracket. See

NOTE in Fig. 21-below.

2. Detail B. Position top C-channel assembly as shown. Attach C-channel assembly to top stinger with sheet

metal screws.

3. Detail C. Position middle C-channel assembly as shown. Attach C-channel assembly to middle stringer

with sheet metal screws.

4. Detail D. Position bottom C-channel assembly as shown. Attach bottom C-channel assembly to concrete

foundation with Tapcon screws.

5. Detail E. Attach cap to each end of system as shown. Attach panels to C-channels with sheet metal

screws.

DETAIL E

TOP VIEW

End cap

This end cap encloses

end of pocket.

DETAIL A

DETAIL B

DETAIL C

DETAIL D

Bracket

8" C-channel

(not supplied)

Metal panel

Sheet metal

screw

4.0"

(10.2 cm)

4.0"

(10.3 cm)

4.0"

(10.3 cm)

Sheet metal

screw

Concrete

8" C-channel

(not supplied)

8" C-channel

(not supplied)

8" C-channel

(not supplied)

FIG. 21

End Pocket

Tapcon screw

NOTE:

C-channel

Should Be Cut

To Length Of

Pocket. 3 Ft.

(91 cm) Is

Recommended.

NOTE: The Drive

pocket bracket

extends outward

farther than the

End pocket

bracket. Make sure

to use correct

bracket.

NOTE: End pocket

bracket extends 3"

(8.9 cm).

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 37 38

Comentarios a estos manuales

Sin comentarios

Hired-hand RollSeal Rollup Curtains: ROLLUP CURTAIN SYSTEM Re Manual de usuario Pagina 29

Comentarios a estos manuales

Relacionado con productos y manuales para Aficionados Hired-hand RollSeal Rollup Curtains: ROLLUP CURTAIN SYSTEM Re