Hired-hand Baffles, Vents, & Inlets: Installing Ceiling I Manual de usuario descargar pdf (Pagina 2)

Part No. 4801-0180 Rev 11-08 Installing Ceiling Inlets Page 2 of 2

STEP 4

Insert the 1/8” Stainless

Steel rod through the inlet. One rod

will activate the doors simultaneously.

See Figure 3.

Measure 18” for CFM4000

or 11” for CFM2000 from center of

pulleys and fasten the nylon cord to

the 1/8” rod using a 1” cable clamp

(1015-1469). See Figure 4.

STEP 5

Thread the

nylon cord through the

pulley then down through

door. Close the door and

slide the plastic ball onto the

cord. Fasten closed with

azuma nut (1015-4000).

See Figures 3 and Figure 4.

STEP 6

STEP 7

Cut off excess cord leaving 3”.

See Figure 4.

NOTE: The cord will stretch, re-adjust

the azuma nut to keep the door fully

closed.

STEP 8

Installation complete.

Controlle

Single Drive

Ceiling Inlet

Figure 3 - Single Rod Assembly

Insulation

Guard

Plastic Ball &

Azuma Nut

Nylon Cord

Door

Rod

Doo

Framing Material

Figure 4 - Pulley Assembly

Drive Rod

Nylon Cord

Plastic Ball

(0013-4000)

Azuma Nut

(1015-4000)

Pulley

Cable Clamps

Figure 5 - Single Drive System Layout

1 2

Installing Ceiling Inlets 1

Comentarios a estos manuales

Sin comentarios

Hired-hand Baffles, Vents, & Inlets: Installing Ceiling I Manual de usuario Pagina 2

Comentarios a estos manuales

Relacionado con productos y manuales para Aficionados Hired-hand Baffles, Vents, & Inlets: Installing Ceiling I